4.28. Coordinate format
4.28.2. Supported coordinate systems and formats
4.28.2.1. Longitude / Latitude in decimal degrees
Longitude / latitude in degrees can be specified as signed decimal fractions:
-33.3553 6.334
That would be about 33° West, 6° North. Note that in this format longitude comes first. The coordinates are assumed to be based on WGS84 (the coordinate system used by the GPS system, and by practically all common navigation systems).
4.28.2.2. Latitude, Longitude (comma-separated)
If the two values are separated by a comma and the text contains no whitespace, Navit interprets them as latitude first, longitude second (the order used by Google Maps and similar tools):
48.1333,11.5666
That is 48°8’ N, 11°34’ E (Munich). Note the inverted order compared to the space-separated formats on this page.
4.28.2.3. Latitude / Longitude in degrees and minutes
Latitude / Longitude can also be specified in degrees and minutes with compass directions (N/S, E/W):
4808 N 1134 E
Here the degrees are multiplied by 100 and the arcminutes are added:
4808 means 48 degrees and 8 arcminutes (48°8’), 1134 means 11
degrees and 34 arcminutes (11°34’), so the position above corresponds
to 48°8’ N, 11°34’ E (Munich).
For greater precision you can write the minutes as decimal fractions:
4808.2356 N 1134.5252 E
That is 48°8.2356’ N 11°34.5252’ E, the center of the Marienplatz in Munich.
Notes:
This format is rather unusual (because it uses arcminutes, but not arcseconds). It is probably easier to just use decimal fractions of degrees.
Separating whitespace is optional:
4808 N 1134 Eand4808N 1134Eare parsed the same way. The only case in which the exact presence of spaces matters is the comma-separated format below, which requires the text to contain no spaces at all.
4.28.2.4. Cartesian coordinates
Internally, Navit uses a cartesian coordinate system induced by a Mercator projection. Coordinates are written as hexadecimal integers:
0x13a3d7 0x5d6d6d
or specifying a projection:
mg: 0x13a3d7 0x5d6d6d
That is again 48°8.2356’ N 11°34.5252’ E. The part up to and including the colon is optional, it names the projection to use. Possible values:
mg - the projection used by Map&Guide (the default)
garmin - “Garmin” projection (TODO: When would it be useful?)
This format is used internally by Navit, but is probably not very useful for other purposes.
4.28.2.5. UTM coordinates
Navit can read coordinates in the Universal Transverse Mercator coordinate system (UTM).
The expected format is:
utm<zone><n|s>: <easting> <northing>
The utm specifier is mandatory: it is followed by the UTM zone
number (1-60) and the hemisphere letter n or s, e.g.
utm32n. The coordinates are the UTM easting and northing in
metres, as given on maps. Example (Frankfurt am Main, zone 32N):
utm32n: 477119 5550910
For the southern hemisphere use s; the northing is then entered in
the usual way and Navit applies the required sign internally.
4.28.3. Development notes
The coordinates are parsed in function coord_parse() in coord.c. This code is used everywhere where Navit parses coordinates, except for the manual coordinate input in the Internal GUI (which uses its own format and parsing function).